Investigation of energy consumption reduction in multistage compression process and its solutions

Document Type : Research Paper

Authors

Department of Mechanical Engineering, Shahrood University of Technology, Shahrood,Iran.

Abstract

During hot seasons the inlet temperature of Nitrogen increases, as a result compressor consumes more power for compressing a specific mass ratio of fluid and consequently total energy consumption of the compressor increases as well. In this research, a three stage centrifugal compressor with intercooler was modeled thermodynamically in order to decreases the energy consumption of the compressor. In each compressor, isentropic efficiency, outlet temperature of the Nitrogen gas and power compression was investigated. The effect of inlet Nitrogen temperature and cooling water temperature on intercoolers’ efficiency were investigated. In this study, Nitrogen gas is considered as an ideal gas. It is found that, in each compressor any growth in inlet temperature of the Nitrogen gas will result in linear increase in the outlet temperature of the Nitrogen gas and power compression furthermore, it is observed that increasing the temperature of Nitrogen gas has the most negative effect on efficiency and power compression of the first compressor in comparison to the second and the third compressor consequently, it will result in a 10 percent decrease in special power compression specially during summer time. According to the results, it is figured out that any growth in inlet Nitrogen temperature causes a smooth decline in isentropic and Power Compression of the first, second and third compressors besides increasing the temperature of the Nitrogen gas increases the isentropic efficiency up to 3 Percent and increasing the cooling water temperature decreases the intercooler efficiency up to 7 Percent.

Keywords

Main Subjects

[1]   W. L. V. Silva, L. C. O. Souza, L. A. Bortolaia, M. R. d. Paula, E. M. Leal, Study of the electricity consumption reduction of a compressed air system: the case of a steelmaking company, REM-International Engineering Journal, Vol. 70, No. 4, pp. 421-428, 2017.
[2]   R. Saidur, N. Rahim, M. Hasanuzzaman, A review on compressed-air energy use and energy savings, Renewable and 336 Sustainable Energy Reviews 14 (4)(2010) 1135–1153. doi: 10.1016/j. rser. 2009.11. 013. 337 [3] A, McKane, Improving energy efficiency of compressed air system based on system audit, Lawrence Berkeley National, Vol. 338.
[3]   Y. Wu, J. Hamilton, W. Shenghong, Optimization of shell-and-tube intercooler in multistage compressor system, 1982.
[4]   A. Sathyaraj, Analysis and performance enhancement of intercooler in two stage reciprocating air compressor using CFD, International Journal of Application in Mechanical and Production Engineering, Vol. 1, pp. 1-5, 2015.
[5]   P. Röyttä, T. Turunen-Saaresti, J. Honkatukia, Optimising the refrigeration cycle with a two-stage centrifugal compressor and a flash intercooler, international journal of refrigeration, Vol. 32, No. 6, pp. 1366-1375, 2009.
[6]   K. Song, C. Jeong, C. Han, Hybrid Compressor Model for Optimal Operation of CDA System, Computer Aided Chemical Engineering, Vol. 28, pp. 889-894, 2010.
[7]   C. Hansen, Dynamic simulation of compressor control systems, Master of Science in Oil and Gas Technology, Aalborg University Esbjerg, 2008.
[8]   H. Wang, Y. Ma, J. Tian, M. Li, Theoretical analysis and experimental research on transcritical CO 2 two stage compression cycle with two gas coolers (TSCC+ TG) and the cycle with intercooler (TSCC+ IC), Energy conversion and Management, Vol. 52, No. 8, pp. 2819-2828, 2011.
[9]   H. Sadeghzadeh, M. Aliehyaei, M. A. Rosen, Optimization of a Finned Shell and Tube Heat Exchanger Using a Multi-Objective Optimization Genetic Algorithm, Sustainability, Vol. 7, No. 9, pp. 11679-11695, 2015.
[10] K. Ghorbanian, M. Gholamrezaei, An artificial neural network approach to compressor performance prediction, Applied Energy, Vol. 86, No. 7, pp. 1210-1221, 2009.
[11] X. Wang, Y. Hwang, R. Radermacher, Investigation of potential benefits of compressor cooling, Applied thermal engineering, Vol. 28, No. 14, pp. 1791-1797, 2008.
[12] P. C. Hanlon, Compressor handbook, 2001.
[13] F. Gui, T. R. Reinarts, R. P. Scaringe, J. M. Gottschlich, Design and Experimental Study of High-Speed Low-Flow-Rate Centrifugal Compressors, MAINSTREAM ENGINEERING CORP ROCKLEDGE FL,  pp. 1995.
[14] R. K. Shah, D. P. Sekulic, 2003, Fundamentals of heat exchanger design, John Wiley & Sons,
[15] S. Azizifar, S. Banooni, Modeling and Optimization of Industrial Multi-Stage Compressed Air System Using Actual Variable Effectiveness in Hot Regions, Journal of Modern Processes in Manufacturing and Production, Vol. 4, No. 2, pp. 29-46, 2015.
Volume 50, Issue 2
December 2019
Pages 219-227
  • Receive Date: 13 December 2017
  • Revise Date: 05 January 2018
  • Accept Date: 09 January 2018